Midea WQP6-3206B Manuale del Proprietario

Technical Service Guide Compact Dishwasher MODEL SERIES: WQP6-3206B IMPORTANT SAFETY NOTICE The information in this service guide is intended for

 4. Remove dispenser. (see dispenser removal and replacement) 5. Remove door handle assembly. (see door handle assembly removal and replacement) 6.

 Part Name: 1 – corner board 2 – absorber 3 – backboard 4 – hollow plate Removal and Replacement 1. Disconnect power supply. 2. Remove sh

 Removal and Replacement 1. Remove shell. (see shell removal and installation) 2. Take out two corner boards, absorber sound, backboard, hollow p

Snap-fits of bottom board Locking terminals Part name: 1 – sheet copper 2 – pressure switch hose 3 – pressure switch 4. Unfix the snap-fi

6. Put out all terminals for connecting Microswitch (door handle assembly), dispenser and rod for door hinges. Take out all connecting lines from in

 Part name: 1 – springs 2 – connecting lines 3 – right front chamber bracket 4 – left front chamber bracket 13. Reverse the above proc

 6. Remove one clamp for fixing connecting hose to check plate holder. 7. Pull out hose for connecting water softener to sump assembly. And pull

 3. Reverse the above procedure to install. And check out all connectors connects well. Removal and replacement 1. Take out sump assembly. (see

 3. Remove all nuts for fixing heater elements assembly. Then take out two gaskets of heater elements assembly. 4. Reverse the above procedur

 Removal and replacement 1. Take out sump assembly. (see sump assembly removal and installation) 2. Pull out check plate holder assembly. 3. Pul

Drain pump assembly ...

 Part name: 1 – Inlet valve block 6. Reverse the above procedure to install. And check out all connectors connects well. Part name: 1 – f

 Part name： 1 – air breather 2 – O ring 3 – gasket of water softener 4 – water softener 5 – connecting hose (water softener) Remova

 SYMPTOM CHECK FOR THE FOLLOWING REMEDY The water supply is turned off. Turn the water supply on. Defective water fill valve. Replace the wate

cycles. A small amount of water (in sump area) is normal. This is necessary to keep the pump primed and is drained automatically at the beginning of

 WQP6-3201 compact electrical dishwasher with 6 washing cycles offers good washing performance to satisfy every washing requirement. Its electronic

 FrontView InteriorView(withbasket)Part Name: 1 – cutlery basket 2 – basket 3 – dispenser InteriorView(WithBasketRemoved)C

 Part Name: 1 – Nut of air breather 2 – Nut of siphon 3 – Cover of softener 4 – Sprayer 5 – Filter System BackView Part Name: 1 – Back

 The main control board controls all electrical elements in the dishwasher machine. It located in the protecting box in the bottom of dishwasher ma

2. Hold on outer door assembly. Remove all screws for fixing the operating board. Part Name: 1 – outer door 2 – handle cover 3 – operating

connecting rod. When activated for the second time in a cycle, the lever lifts the connecting rod by the notch, lifting the rinse dispenser plunger a

 4. Remove all screws for fixing door handle assembly. 5. Reverse the above procedure to install. And check out all connectors connects well.